Push In Flange Protectors

Push In Flange Protectors

Push in flange protectors which conform to the highest standards in the chemical industry. We manufacture these products in yellow low density polyethylene except for the PFP155 which is a special natural version.

These flange protectors are designed to cover the entire face including bolt holes on 150lbs ranges. However, you can use them for all class ratings, depending on bore hole size.

You can order these flange protectors from the table directly below.

The flange protectors have flexible fins for an easy and snug fit into the bore hole of the flange face. As a result, the end user can remove the protector very easily.

Due to their snug fit, they protect well against dirt and dust ingress. In addition, they are used for masking purposes when finishing.

The flange protectors are reusable for a number of times, and the low density polyethylene is widely recyclable.

Thredgards also manufacture and supply other flange protection solutions. Therefore, please have a look at our stud hole protector, flange face protector, and flange protection disc ranges. We can also supply self adhesive flange protectors which are not yet currently listed on the site. Please contact us to discuss this option.

We can also supply you with a free sample should you wish to try them first in your application. 

Please do not hesitate to contact us should you have any specific requirements. Our technical sales advisers are always ready to help.

Typical application of one of our push in flange protectors on two steam control valves. Note the flush fitting and ease of application.